Field-IQ Support and Downloads


Field-IQ Initial Settings
Setting up the Field-IQ system on a sprayer for the first time? Make your life easier and use this document to gather the information that is needed before going through the setup.


CFX-750 with Field-IQ Entered Settings vs 1.9
Upgrading your CFX-750/FIQ on a sprayer from vs. 1.9 to a later version? Because of all the changes in firmware the Field-IQ settings cannot be saved in a configuration file and reloaded. Use this worksheet to write down the settings that are stored in version 1.9 BEFORE you upgrade.


Module Firmware Comments
Each of the devices that connect to the displays contains programming called firmware. When the firmware is changed on the display, the firmware in all the connected devices may need to be changed. Firmware upgrades are done through the display, when the modules are connected to the display. A sprayer using Field-IQ normally has three modules, as listed below, so download each file and save it to the USB drive. Upgrade the modules through the display, after the display has been updated.

Field-IQ Section Switch Module Firmware - v3.05 (release 01-20-13)
Use version 3.05 with firmware vs. 4.0 on the CFX-750.

Field-IQ Master Switch Module Firmware - v3.05 (release 01-20-13)
Use version 3.05 with firmware vs. 4.0 on the CFX-750.

Field-IQ Rate and Section Control Module Firmware - v3.05 (release 01-20-13)
Use version 3.05 with firmware vs. 4.0 on the CFX-750.


Raven Cabling for Field-IQ

CFX-750 / Field-IQ Rate and Section control to Raven 4X0 or AgGPS EZ-Boom harness

FmX with Field-IQ Quick Reference Card